Error Code 8C2
Your washer's vibration sensor has a connection problem.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C2
What This Means
Wire connections to MEMS PBA disconnected or loose; MEMS PBA hardware fault
What actually causes this:
The cable to the vibration sensor board came loose from vibration during spin cycles.
First Thing to Check
Unplug the washer for 2 minutes, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check the wire connections to the MEMS PBA
- 2
2. Verify connector is fully seated
- 3
3. Replace the MEMS PBA if necessary
Other Error Codes for WF45N5300AW
An internal communication module in your washer has lost its connection.
Your washer's vibration sensor has a general fault.
Your washer's main computer board has crashed and cannot recover.
Your washer's door lock mechanism has a hardware fault.
Your washer's motor controller has lost communication with the main board.
Your washer is not getting enough water to start or continue the cycle.
Your washer is not getting enough electrical power to run properly.
Your washer cannot detect the water level inside the drum.