Error Code DDC
The small Add Door on the washer's main door is not fully closed.
Moderate
Address soon - your appliance may not work properly
Also displayed as: dDC
What This Means
Switch contact error due to deformation of the Add Door switch; Add Door was pulled open by force; During Boil wash, Add Door is pushed due to pressure difference from internal temperature changes; Add Door open/close switch fault; Main PCB fault
What actually causes this:
The Add Door was not pushed shut properly after adding an item mid-cycle.
First Thing to Check
Push the small Add Door on the front of the washer firmly closed until it clicks.
Parts Involved
How to Fix
- 1
1. Check the Add Door — the Add Door is opened means DDC is displayed when you press the door button
- 2
2. Check the Add Door switch, Barrier, and Lock for normal operation
- 3
3. Check that the module's movement operates normally (Open detection switch and Barrier)
- 4
4. If the Add Door is not opened, need to check DDC switch fault
- 5
5. Check Main PCB fault
Other Error Codes for WF50K7500AW
The washer's display screen has lost communication with the main board.
The washer's door lock mechanism is not working properly.
The washer cannot pump out the water after a cycle.
The control panel and the main computer board are not communicating.
The washer's motor cannot spin or is struggling to turn.
The washer cannot detect how much water is in the tub.
The washer is receiving too much electrical power.
The washer's WiFi module has lost communication with the main board.