Error Code DC
The washer does not detect that the door is closed
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC
What This Means
Door switch fault; Main PCB door sensing circuit fault; Door not fully closed; Laundry caught in the door; Door switch wiring fault
What actually causes this:
The door was not pushed shut firmly, or a piece of clothing is caught in the door seal
First Thing to Check
Make sure nothing is caught in the door, close it firmly, and try again
Parts Involved
How to Fix
- 1
1. Verify the door is fully closed and no laundry is caught in the seal
- 2
2. If a DC error occurs, check whether it occurs during the Boil cycle
- 3
3. Check the door switch resistance — pins 1 and 3 should read approximately 175 ohms
- 4
4. Check and repair the power wire connections and insulation state (120V is directly connected to the door)
- 5
5. If the door switch is faulty, replace it
- 6
6. Check the main PBA door sensing circuit — replace if faulty
Other Error Codes for WF53BB8700ATUS
The water heater or its temperature sensor is not working right
The washer thinks there is too much water inside
The washer cannot properly detect how much water is inside
The washer has detected a water leak
The water temperature sensor is not reading correctly
The washer detected an electrical problem with its power or motor circuit
The washer's main control board and display board are not communicating
The main control board and motor driver board stopped talking to each other