Error Code LE
Motor Error - washing motor operating abnormally
Moderate
Address soon - your appliance may not work properly
What This Means
Wiring connection issue at RD3 connector; Impeller of washing motor locked; Washing motor resistance out of range (should be 22.5-24.9 ohms at 20 degrees C); Controller damaged
How to Fix
- 1
Check connector at RD3; reconnect wire if disconnected
- 2
If washing motor impeller is locked: replace pump casing assembly
- 3
Check washing motor resistance (22.5-24.9 ohms at 20 degrees C); replace pump casing assembly if out of range
- 4
Check resistance between housing connector pins (Pin1-Pin2, Pin2-Pin3, Pin3-Pin1); value should not be 0-50 ohms short
- 5
Replace main PCB assembly if all components check out
Other Error Codes for LSDF9897BB
EEPROM failure (displayed during test mode - Start pressed 1 time after entering test mode)
Bubble Error - oversudsing detected
Thermal Error - thermistor resistance output abnormal
Heater Error - water not heated or tub overheated above 194 degrees F
Drain Error - unit does not reach normal drain level
Leakage Error - internal leakage detected
Excess Error - water fills above normal level (drain pump operates automatically)
Inlet Error - unit does not reach normal water level