Error Code LE
Motor Error — washing motor operating abnormally
Moderate
Address soon - your appliance may not work properly
What This Means
Wiring connection to washing motor (connector RD3) disconnected; Impeller of washing motor locked; Washing motor faulty (resistance should be 22.5-24.9 ohm at 20°C); Controller damaged
How to Fix
- 1
Check connector RD3 connection; reconnect wire if disconnected
- 2
If impeller of washing motor locked: replace pump casing assembly
- 3
Check washing motor resistance: should be 22.5-24.9 ohm at 20°C; replace pump casing assembly if not
- 4
After pulling out RD3 connector, check housing connector resistance between Pin1-Pin2, Pin2-Pin3, Pin3-Pin1 (should not be 0-50 ohm short)
- 5
Replace main PCB assembly if all checks pass
This Error Applies To
LG LDF5545ST Series Dishwashers
Related Error Codes
Drain Error — machine does not reach normal drain level (motor RPM not increasing or drain blocked)
EEPROM failure (displayed during test mode)
Heater Error — water not heated or tub overheated to over 194°F
Leakage Error — internal leakage detected by float switch in base
Bubble Error — oversudsing detected
Thermal Error — thermistor resistance output abnormal
Vario Error — vario cam position not properly detected
NFC or Wi-Fi module failure (displayed during test mode POWER+START)