How do I fix error code nP on a LG dryers?

1. undefined: Check the wall outlet voltage — must be 208–240 Vac ±10% for electric models. 2. undefined: Verify the power cord is fully seated in the NEMA 14-30R or 10-30R receptacle. 3. undefined: Check terminal block connections inside the dryer. 4. undefined: Reset circuit breaker or replace fuse. 5. undefined: If outlet voltage is out of range, contact a licensed electrician.

LG Dryers2023–present

Error Code nP

No power / power code error — outlet voltage issue or power cord not properly connected

Moderate

Address soon - your appliance may not work properly

Also displayed as: nP

How to Fix

1
Check the wall outlet voltage — must be 208–240 Vac ±10% for electric models.
2
Verify the power cord is fully seated in the NEMA 14-30R or 10-30R receptacle.
3
Check terminal block connections inside the dryer.
4
Reset circuit breaker or replace fuse.
5
If outlet voltage is out of range, contact a licensed electrician.

This Error Applies To

LG DLE8400BE Series Dryers (2023) (2023–present)

Service manual exact match: DLG8401WEService manual exact match: DLE8400BEService manual exact match: DLE8400WEService manual exact match: DLG8401BE

Related Error Codes

Power supply error — electric dryer power cord not connected correctly or house power supply incorrect; also displayed when 240V is applied to PCB indicating mis-wired power cord

d90

Duct blockage — ductwork approximately 90% blocked (displayed for 2 hours only)

tE1

Temperature sensor (thermistor) failure — open circuit

Power failure — house fuse blown, circuit breaker tripped, or power outage

d95

Duct blockage — ductwork approximately 95% blocked (displayed for 2 hours only)

tE2

Temperature sensor (thermistor) failure — shorted circuit

dSo

Flow Sense duct blockage restriction detected after drying cycle ends

Humidity (moisture) sensor failure

Need more help with your LG dryers?