How do I fix error code tE2 on a LG dryers?

1. undefined: Follow the same diagnostic procedure as tE1. 2. undefined: Turn power off and discharge capacitors. 3. undefined: Remove connector NA6 and short Pin 2 (Blue Wire) and Pin 5 (Orange Wire) to the controller. 4. undefined: If error clears, verify harness connections and replace controller if needed. 5. undefined: If error persists, measure thermistor resistance and compare to Table 1 values. 6. undefined: Replace thermistor if out of range; inspect harness connector if in range.

LG Dryers

Error Code tE2

Thermistor fault — blower housing thermistor open or shorted (alternate code)

Moderate

Address soon - your appliance may not work properly

Also displayed as: tE2

How to Fix

1
Follow the same diagnostic procedure as tE1.
2
Turn power off and discharge capacitors.
3
Remove connector NA6 and short Pin 2 (Blue Wire) and Pin 5 (Orange Wire) to the controller.
4
If error clears, verify harness connections and replace controller if needed.
5
If error persists, measure thermistor resistance and compare to Table 1 values.
6
Replace thermistor if out of range; inspect harness connector if in range.

This Error Applies To

LG DLEX7900VE Series Dryers

Service manual exact match: DLEX7900WEService manual exact match: DLGX7901WEService manual exact match: DLEX7800VEService manual exact match: DLGX7801VEService manual exact match: DLEX7800WEService manual exact match: DLGX7801WEService manual exact match: DLEX7900VEService manual exact match: DLGX7901VE

Related Error Codes

tE4

Steam generator thermistor open or shorted

Humidity sensor failure

Steam pump AD value below 10 — pump abnormal

EEPROM error — EEPROM operation is abnormal

d80

FlowSense four-bar restriction detected — ductwork significantly restricted

Door switch abnormal — detected only in TEST MODE

d90

Ductwork approximately 90% blocked — FlowSense alert

tE1

Thermistor fault — blower housing thermistor open or shorted

Need more help with your LG dryers?