Error Code C-23
Meat probe sensor circuit shows abnormally low resistance
Moderate
Address soon - your appliance may not work properly
Also displayed as: C-23
What This Means
Probe harness disconnected; Probe connector damaged; Probe sensor shorted; Main PCB sensing circuit failure
What actually causes this:
Corroded probe, water damage to connector, or wire damage
First Thing to Check
Inspect meat probe and connector for visible corrosion or damage
Parts Involved
How to Fix
- 1
Disconnect power and probe harness from control board
- 2
Measure probe resistance (should be ~50k ohms at room temperature)
- 3
Check wire harness and connector terminals for damage
- 4
Measure probe connector resistance on Main PCB (normal 10k-11k ohms)
This Error Applies To
Samsung DOC30P977D Series Ovens & Ranges
Related Error Codes
Broil heating element not energizing during self-test
Partition configuration changed during active cooking cycle
Cooling motor not responding to control signals
Loss of communication between main control and touch display panel
Drain system unable to evacuate water within time limit
Loss of communication between main control board and sub control board
Temperature sensor circuit is open - no resistance reading possible
Main control board temperature sensor reads excessive heat