Error Code H-3
Bake heating element not energizing during self-test
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: H-3
What This Means
Bake heater element failure; Bake heater wire disconnected; Wall Main PCB relay failure; Wall Main PCB failure
What actually causes this:
Heater element burnt out, loose connection, or PCB relay failure
First Thing to Check
Verify bake heater wires are connected to Wall Main PCB terminals T206-T207
Parts Involved
How to Fix
- 1
Check bake heater operation and wire connections (T206, T207 on Wall Main PCB)
- 2
Verify heater wire is connected correctly to PCB terminals
- 3
Measure heater resistance (should be 18-21 ohms at room temp)
- 4
Test relay operation during bake mode
This Error Applies To
Samsung DOC30P977D Series Ovens & Ranges
Related Error Codes
Keypad short circuit detected
Main control board temperature sensor reads excessive heat
Partition configuration changed during active cooking cycle
Broil heating element not energizing during self-test
Cooling motor not responding to control signals
Steam sensor circuit is open - no temperature feedback
Loss of communication between main control and touch display panel
Drain system unable to evacuate water within time limit