Error Code 4E
The washer isn't filling with water
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4E
What This Means
Foreign material entering water supply valve; Water supply valve terminal not connected (wire disconnected); Warm water and rinse connectors incorrectly switched; PCB terminal from drain hose to detergent drawer not connected; Transparent hose folded or torn; Cold and warm water supply hoses incorrectly switched; Water temperature sensed as higher than 50°C in Wool/Delicates for 8 seconds; Freezing in winter
What actually causes this:
The water supply faucets are closed or the inlet filter is clogged
First Thing to Check
Make sure both water faucets behind the washer are fully turned on
Parts Involved
How to Fix
- 1
1. Measure water supply valve resistance: 0.9KΩ to 1.1KΩ between terminals
- 2
2. Check for foreign material in water supply valve filter
- 3
3. Check that cold and hot supply hoses are correctly connected
- 4
4. Check if water is supplied to machine, check for freezing
- 5
5. If PBA relay operates abnormally, replace PBA
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WA456DRHDS Series Washers (2012) (2012–present)
Related Error Codes
The washer can't detect the water level properly
The washer's motor isn't working
The washer can't drain the water out
The control boards inside the washer can't communicate
A button on the washer control panel appears stuck
The washer lid detected an opening while trying to start
The washer door won't unlock after the cycle finishes
The washer lid won't lock