Error Code 8E
An internal vibration sensor has stopped working
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8E
What This Means
MEMS sensor output voltage out of range (>4.5V or <0.5V); MEMS PBA defective; Wire connector terminals disconnected
What actually causes this:
The vibration sensor board wiring came loose or the sensor failed
First Thing to Check
Unplug the washer for a few minutes and try again
Parts Involved
How to Fix
- 1
1. Check MEMS sensor and PBA
- 2
2. Check wire connector terminals
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WA456DRHDS Series Washers (2012) (2012–present)
Related Error Codes
The washer can't detect the water level properly
The washer's motor isn't working
The washer isn't filling with water
The washer can't drain the water out
The control boards inside the washer can't communicate
A button on the washer control panel appears stuck
The washer lid detected an opening while trying to start
The washer door won't unlock after the cycle finishes