Error Code 8E
The motion sensor inside the washer is not working correctly
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8E
What This Means
MEMS sensor defective; Main PBA fault; Wire connector terminal disconnected or faulty
What actually causes this:
The vibration sensor (MEMS) has malfunctioned or its wiring is loose
First Thing to Check
Unplug the washer, wait 60 seconds, and plug it back in — if the error returns, it needs service
Parts Involved
How to Fix
- 1
1. Check the MEMS sensor and PBA
- 2
2. Check the wire connector terminals
- 3
3. If MEMS sensor output is out of range (below 0.5V or above 4.5V), replace the sensor
- 4
4. If sensor tests normal, replace Main PBA
This Error Applies To
Samsung WA456DRHDW Series Washers (2012) (2012–present)
Related Error Codes
The washer cannot detect how much water is in the tub
The washer's motor cannot spin or is detecting a problem
The washer is not getting enough water to fill
The washer cannot pump the water out
The washer's control boards cannot communicate with each other
A button on the control panel appears to be stuck
The washer does not detect the door as properly closed
The washer cannot unlock the door after a cycle