Error Code PC1
The clutch sensor is sending the wrong signal to the control board.
Moderate
Address soon - your appliance may not work properly
Also displayed as: PC1
What This Means
Incorrect clutch hall signal after position detection; Clutch hall sensor defective; Clutch mechanism worn or damaged; Defective main PCB
What actually causes this:
The clutch sensor has worn out or its signal wiring has come loose.
First Thing to Check
Unplug the washer for one minute and plug it back in.
Parts Involved
How to Fix
- 1
1. Turn off the washer, unplug it, wait one minute, then plug in again
- 2
2. Inspect the clutch hall sensor and wiring
- 3
3. Contact Samsung customer service if issue persists
This Error Applies To
Samsung WA46CG3505 Series Washers (2024) (2024–present)
Related Error Codes
The vibration sensor that helps keep the washer balanced is not working.
The vibration sensor board is not communicating properly.
The vibration sensor board has a hardware fault.
The washing machine motor is not spinning or responding properly.
The cold water hose is hooked up to the hot water faucet.
The laundry inside is bunched up on one side, so the washer cannot spin safely.
The washer is getting too much voltage from the electrical outlet.
The washer is not getting enough voltage from the electrical outlet.