Error Code 4E2
The hot and cold water hoses are connected to the wrong faucets
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4E2
What This Means
Hot water hose connected to cold water inlet and vice versa; Hoses connected to wrong faucets
What actually causes this:
The water hoses were accidentally swapped during installation — hot is where cold should be
First Thing to Check
Check the hose connections at the back of the washer — make sure the hot hose goes to the hot faucet and cold to cold
Parts Involved
How to Fix
- 1
1. Verify the hot water hose is connected to the hot water faucet
- 2
2. Verify the cold water hose is connected to the cold water faucet
- 3
3. Swap hose connections if reversed
This Error Applies To
Samsung WA48H7400A Series Washers (2014) (2014–present)
Related Error Codes
The washer cannot drain the water out
The washer lid is stuck and will not unlock
The washer is not getting enough water
Water is leaking from the washer during a cycle
The water level sensor is not reading correctly
The washer detected too much water and is trying to drain
The laundry load is off-balance and the washer cannot spin
The washer lid is not closing or latching properly