Error Code 8E
The vibration sensor inside the washer is malfunctioning
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8E / 8E1 / 8E2
What This Means
MEMS sensor fault; PBA fault; Wire connector terminal fault
What actually causes this:
The vibration sensor circuit board has a loose connection or has failed
First Thing to Check
Unplug the washer for 2 minutes and restart — if the error returns, it needs service
Parts Involved
How to Fix
- 1
1. Check the MEMS sensor and PBA
- 2
2. Check the wire connector terminals for loose or damaged connections
- 3
3. Measure MEMS sensor output voltage — normal range is 0.5V to 4.5V
- 4
4. If MEMS sensor is faulty, replace the PBA (sensor is integrated)
This Error Applies To
Samsung WA48H7400A Series Washers (2014) (2014–present)
Related Error Codes
The washer cannot drain the water out
The hot and cold water hoses are connected to the wrong faucets
The washer lid is stuck and will not unlock
The washer is not getting enough water
Water is leaking from the washer during a cycle
The water level sensor is not reading correctly
The washer detected too much water and is trying to drain
The laundry load is off-balance and the washer cannot spin