Error Code 8E
A vibration sensor inside your washer has a problem
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8E
What This Means
MEMS PBA general fault; Wire connection fault
What actually causes this:
The vibration sensor board has a loose wire or has gone bad
First Thing to Check
Turn off the washer, wait a minute, and restart — if the error returns, it needs service
Parts Involved
How to Fix
- 1
1. Check the wire connections to the MEMS PBA
- 2
2. Replace the MEMS PBA if necessary
This Error Applies To
Samsung WF42H5200A Series Washers (2014) (2014–present)
Related Error Codes
The washer motor is struggling to spin the drum
Your washer can't tell how much water is inside
The incoming water is too hot for the selected cycle
Your washer isn't getting water
Your washer can't pump the water out
Your washer is getting unreliable power from the outlet
A control module inside your washer has lost its connection
The motor speed controller lost its connection to the main control board