Error Code 4C
Your washer is not getting enough water to start or continue the cycle.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4C
What This Means
Foreign material entering the water supply valve; Water supply valve terminal not connected or wire disconnected; Warm water and rinse connectors are wrongly connected to each other; PCB terminal from drain hose to detergent drawer not connected; Transparent hose is folded or torn
What actually causes this:
Usually the water faucets behind the washer are not fully turned on, or the inlet hose screens are clogged with sediment.
First Thing to Check
Make sure both hot and cold water faucets behind the washer are fully turned on.
Parts Involved
How to Fix
- 1
1. Verify that water supply faucets are fully open
- 2
2. Check for foreign material in the water supply valve inlet screens
- 3
3. Inspect the water supply valve wire terminal connections
- 4
4. Verify warm water and rinse connectors are connected to the correct ports
- 5
5. Confirm the transparent hose from drain to detergent drawer is not folded or torn
- 6
6. Check PCB terminal connections
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WF45N5300A Series Washers (2017) (2017–present)
Related Error Codes
An internal communication module in your washer has lost its connection.
Your washer's vibration sensor has a general fault.
Your washer's main computer board has crashed and cannot recover.
Your washer is not getting enough electrical power to run properly.
Your washer cannot detect the water level inside the drum.
The water coming into your washer is too hot for the selected cycle.
Your washer is getting too much electrical power from the outlet.
Your washer's WiFi module has lost its connection to the main board.