Error Code 8C1
Your washer's vibration sensor has detected a fault.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C1
What This Means
Error detected in the MEMS PBA; Data error detected from MEMS sensor; Wire connections loose or disconnected
What actually causes this:
The sensor that helps the washer detect vibration and balance has a loose connection or has failed.
First Thing to Check
Unplug the washer for 2 minutes, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check the wire connections to the MEMS PBA
- 2
2. Verify the MEMS PBA connector is fully seated
- 3
3. Replace the MEMS PBA if necessary
This Error Applies To
Samsung WF45N5300A Series Washers (2017) (2017–present)
Related Error Codes
An internal communication module in your washer has lost its connection.
Your washer's vibration sensor has a general fault.
Your washer's main computer board has crashed and cannot recover.
Your washer is not getting enough water to start or continue the cycle.
Your washer is not getting enough electrical power to run properly.
Your washer cannot detect the water level inside the drum.
The water coming into your washer is too hot for the selected cycle.
Your washer is getting too much electrical power from the outlet.