Error Code BC2
A button on the control panel is stuck
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Switch jammed or stuck due to uneven press from deformed control panel or button; Screws holding the sub PBA tightened too much, pressing on a button; A button other than Power is continually pressed for more than 30 seconds; Deformation of an internal plastic injection part; Sub PBA assembly screw tightened too much
What actually causes this:
One of the buttons on the front panel got stuck in the pressed position
First Thing to Check
Press each button on the control panel to see if any feel stuck or don't spring back
Parts Involved
How to Fix
- 1
1. Check all buttons on the control panel — ensure none are physically stuck
- 2
2. Check that the control panel is not deformed or warped
- 3
3. Check the screws holding the sub PBA — if over-tightened, loosen slightly
- 4
4. Check internal plastic injection parts for deformation
- 5
5. Replace sub PBA if faulty
This Error Applies To
Samsung WF50R8500A Series Washers (2019) (2019–present)
Related Error Codes
The washer's main computer chip has failed
The washer's motor can't spin properly
The washer's door lock mechanism has a problem
Your washer isn't getting enough electrical power
Your washer is getting too much electrical power
The incoming water is too hot for delicate wash cycles
The washer's display screen lost its connection to the main board
An internal communication module lost its connection