Error Code BE2
A button on the control panel is stuck or being held down too long.
Moderate
Address soon - your appliance may not work properly
Also displayed as: BE2
What This Means
Power button is pressed continually for more than 12 seconds; A switch is jammed or stuck due to being pressed unevenly from control panel or button deformation; Screws that hold the sub PBA in place are tightened too much; A button other than the Power button is continually pressed for more than 30 seconds; Deformation of an internal plastic injection part; Main PBA relay fault; Main PBA on/off switching IC fault
What actually causes this:
Usually a button on the control panel is physically stuck or jammed from spilled detergent or moisture.
First Thing to Check
Press each button on the control panel a few times to make sure none are stuck. Wipe the panel clean if there is any sticky residue.
Parts Involved
How to Fix
- 1
1. Check whether the Power button or any other button is pressed continuously
- 2
2. Check the contact between control panel buttons and their corresponding tact switch
- 3
3. There must be a gap between a control panel and the holding PBA service screws — check if screws are fastened too much
- 4
4. If screws are too tight, loosen them a little
- 5
5. Check the main PBA relay on/off switching IC — if a check has occurred, replace the main PBA after approx. 30 seconds has passed
This Error Applies To
Samsung WW22K6800AW Series Washers (2015) (2015–present)
Related Error Codes
A door-related communication module has lost contact with the main board.
The washer's vibration sensor board has a problem.
The washer's main computer chip has failed.
The washer's main computer chip has failed.
The washer's main computer chip has failed.
An internal communication board has lost contact with the main control board.
The washer cannot detect the water level inside the tub.
The washing machine motor is not spinning correctly.