Error Code TE1
The washer cannot read the water temperature correctly.
Moderate
Address soon - your appliance may not work properly
Also displayed as: TE1
What This Means
Washing heater sensor in the tub has a contact check or temperature sensor fault; Connector is connected incorrectly or is disconnected; Water level sensor operates without water due to freezing; Temperature sensor detects 100 to 150 degrees C and the washer turns off input power; Faulty and incorrect connections of the washing temperature sensor connector; Wash heater temperature sensor fault; Freezing in the winter season
What actually causes this:
A loose temperature sensor connector, often vibrated loose over time.
First Thing to Check
Unplug the washer for 5 minutes, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check the connections for the washing temperature sensor connector
- 2
2. If the washing heater temperature sensor has a functional error, replace it
- 3
3. A TE1 check occurs when the connector is connected incorrectly or has a wire disconnected or contact issue
This Error Applies To
Samsung WW22K6800AW Series Washers (2015) (2015–present)
Related Error Codes
A door-related communication module has lost contact with the main board.
The washer's vibration sensor board has a problem.
The washer's main computer chip has failed.
The washer's main computer chip has failed.
The washer's main computer chip has failed.
An internal communication board has lost contact with the main control board.
The washer cannot detect the water level inside the tub.
The washing machine motor is not spinning correctly.