Error Code DC2
The door lock mechanism is not working correctly
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC2
What This Means
Door lock switch unit is not inserted; Door lock switch unit is damaged; Wire is disconnected; Door lock switch unit is defective; Main PCB is defective
What actually causes this:
The door latch mechanism has failed or the lock switch wiring has a problem
First Thing to Check
Try opening and firmly closing the lid again, pressing it down until you hear a click
Parts Involved
How to Fix
- 1
1. Check whether the door lock switch unit is properly inserted
- 2
2. Check whether the door lock switch unit is damaged
- 3
3. Check for disconnected wires
- 4
4. Measure the resistance for Lock/Unlock Contact — Lock (Checking Part: White-Red Wire), Unlock (Checking Part: White-Blue Wire) — should be approximately 0.2 ohms between terminals
- 5
5. Check the Door Lock/Unlock state
- 6
6. If the door lock switch unit is defective, replace it
- 7
7. If the main PCB is defective, replace it
Other Error Codes for WA54CG7105AD
The washer's motor has stopped working
The washer is not getting any water
The washer is getting too much voltage from the outlet
The washer is not getting enough voltage from the outlet
The heater or temperature sensor has a problem
The washer thinks the lid is open
The washer has too much water inside
The washer cannot find the position of its internal clutch