Error Code 9C2
The washer is not getting enough voltage from the outlet
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9C2
What This Means
Power cord is not plugged in properly; Low voltage from electrical outlet; Extension cord causing voltage drop; Main PBA fault
What actually causes this:
The washer is plugged into an extension cord or the outlet voltage is too low
First Thing to Check
Make sure the power cord is firmly plugged into the wall outlet and not using an extension cord
Parts Involved
How to Fix
- 1
1. Check if the power cord is plugged in securely
- 2
2. Check the consumer's power conditions and measure the operating voltage
- 3
3. Check whether a plug receptacle (extension cord) is being used — extension cords can cause voltage drops up to 10V
- 4
4. Turn off the washer, unplug it, wait one minute, and plug it back in
- 5
5. If the information code remains, replace the main PBA
Other Error Codes for WA55CG7100AW
The washer's motor has stopped working
The washer is not getting any water
The washer is getting too much voltage from the outlet
The heater or temperature sensor has a problem
The washer thinks the lid is open
The door lock mechanism is not working correctly
The washer has too much water inside
The washer cannot find the position of its internal clutch