Error Code BC2
A button on the control panel is stuck or pressed in
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Switch jammed or stuck due to uneven pressing from control panel deformation; Screws holding the sub PBA are tightened too much; Button other than Power button is continually pressed for over 30 seconds; Deformation of an internal plastic injection part; Sub PBA assembly screw tightened too much
What actually causes this:
One of the buttons on the control panel got stuck — sometimes from a spill that dried and made the button sticky
First Thing to Check
Press each button on the control panel to check if any feel stuck or don't spring back
Parts Involved
How to Fix
- 1
1. Check if any button on the control panel is stuck or jammed
- 2
2. Check whether the sub PBA screws are overtightened, causing panel deformation
- 3
3. Check for deformed internal plastic injection parts pressing on buttons
- 4
4. Loosen and re-tighten the sub PBA screws to proper torque
Other Error Codes for WF45R6300AW
The washer's motor can't spin the drum properly
The incoming water is too hot for delicate wash cycles
The door lock mechanism won't engage
The washer detects the door opening while running
The washer has too much water in the tub and is overflowing
There are too many soap suds in the washer
The washer's vibration sensor detected a problem
Your washer's small add-clothes door is not closing properly.