Error Code LC
The washer has detected a water leak inside the machine.
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: LC/LC1
What This Means
Heater engagement fault (out of place); Air hose out of place causing water leakage during spin; Tub back at safety bolt fixing part is broken; Excessive detergent causing foaming and front leakage; Connecting hose to detergent drawer connected incorrectly; Drain pump filter cover engaged incorrectly; Water leakage at drain hose; Duct condensing holding screws worn; Nozzle-diaphragm engaged in opposite direction or rubber packaging omitted; Tub back and front holding screws fastened incorrectly; Leakage sensor fault; Foreign material in DV case; Faulty hose or incorrect part engagement
What actually causes this:
Most commonly caused by using too much detergent (which creates excess foam that leaks out the front) or a loose/cracked drain hose connection.
First Thing to Check
Reduce the amount of detergent you use — try using half as much. Check under and around the washer for visible water.
Parts Involved
How to Fix
- 1
1. Check for any leakage on the base, hose, valve, and tub connections
- 2
2. Check heater engagement — ensure properly seated in bracket
- 3
3. Check all hose connections and clamps
- 4
4. Check drain pump filter cover engagement
- 5
5. Check drain hose for leaks
- 6
6. Check nozzle-diaphragm orientation and rubber packaging
- 7
7. Check drain motor operation — replace if not operating normally
- 8
8. Verify tub screws are properly fastened
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WW22N6850QX
The main board and motor inverter have lost communication.
The washer cannot detect the water level correctly.
The washing machine motor is not spinning properly.
The motor is drawing too much power or not reaching the right speed.
The washer cannot pump the water out.
The control panel and the main computer board are not communicating.
The main computer and motor driver boards are not communicating.
The washer's WiFi module is not communicating with the main board.