Error Code tE2
Temperature sensor error 2 — outlet thermistor at blower housing is open or shorted. Displayed during drying cycle or test mode.
Moderate
Address soon - your appliance may not work properly
What This Means
Outlet thermistor open or shorted; Harness connector loose or disconnected; Defective main PCB
How to Fix
- 1
Turn off dryer and disconnect from power
- 2
Discharge voltage by contacting metal plug of power cord with ground
- 3
Disconnect NA6 connector from main PCB
- 4
Short pin 1 (Blue wire) and pin 2 (Orange wire) of NA6 connector with a metal jumper
- 5
If controller responds, check harness connections
- 6
Disconnect harness from thermistor assembly and measure resistance against Table 1 temperature values
- 7
If resistance out of range, replace thermistor assembly
- 8
If resistance is in range, check and repair harness connector
Other Error Codes for DLEX6700B
Temperature sensor error 1 — outlet thermistor at blower housing is open or shorted. Displayed during drying cycle or test mode.
Steam water supply error — DC pump AD value is less than 10 in diagnostic test mode.
FlowSense duct blockage 80% — ductwork approximately 80% blocked. Error displayed for 2 hours only.
FlowSense duct blockage 95% — ductwork approximately 95% blocked. Error displayed for 2 hours only.
Door open or door switch abnormal. During normal operation displays when door is opened mid-cycle. In test mode indicates door switch fault.
Steam generator thermistor open or shorted. Displayed only in diagnostic test mode.
FlowSense duct blockage 90% — ductwork approximately 90% blocked. Error displayed for 2 hours only.