Error Code HC
Your dryer isn't heating properly or is overheating
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: HC
What This Means
Restricted vent system causing excessive heat buildup; Thermistor failure or resistance out of range; Heater malfunction (open or shorted element); Thermostat failure; PCB malfunction in temperature monitoring circuit; Compressor terminal wiring desorption (pin connection issue)
What actually causes this:
Most often caused by a clogged exhaust vent that traps hot air inside the dryer, or the heating element has burned out.
First Thing to Check
Check your exhaust vent — disconnect it from the back of the dryer and look for lint buildup inside.
Parts Involved
How to Fix
- 1
1. Check the PCB and Thermistor
- 2
2. Measure thermistor resistance: should be 10K ohm at 25 deg C (77 deg F)
- 3
3. Check thermostat 1 resistance: should be < 1 ohm (infinity means replace)
- 4
4. Check thermostat 2 resistance: should be < 1 ohm (infinity means replace)
- 5
5. Check thermostat 3 resistance: should be < 1 ohm (infinity means replace)
- 6
6. Check heater: SINGLE — 10 ohm (PIN 1-3); DUAL — 13 ohm (PIN 2-3) and 34 ohm (PIN 1-2)
- 7
7. If any resistance is infinite, replace the corresponding component
- 8
8. For gas models, check igniter resistance: 40-400 ohm; check gas valve coil resistances
- 9
9. Operate time dry for 20 minutes after service and verify HC error does not recur
Other Error Codes for DVG45R6300P
Your dryer is getting the wrong voltage from the outlet
The dryer's internal parts aren't communicating properly
A button on the control panel is stuck or shorted
The dryer thinks the door is open while running
The door switch isn't working properly
Your dryer's temperature sensor isn't reading correctly
A secondary temperature sensor is giving bad readings
Your dryer is getting the wrong type of electrical power