Error Code AE

Leakage Error — internal water leak detected by float/safety switch in base

What This Means

Door gasket came loose or fell off; Float assembly (safety switch) stuck; Controller (main PCB) damaged; Seal assembly on sump not properly connected; Unit not leveled correctly; Wrong detergent used (non-dishwasher detergent causing sudsing); Door opened during cycle

How to Fix

1. 1

   Check if water is flooded in the base; if yes, tilt machine and drain water from base

2. 2

   After draining, inspect drain hose sealing, pump casing assembly, and vario motor for source of leak

3. 3

   If leak source found, reassemble or replace the leaking part

4. 4

   Check if safety switch assembly is stuck; if yes, replace safety switch assembly

5. 5

   Check if door gasket came loose or fell off; if yes, replace door liner assembly

6. 6

   Verify machine is leveled properly using a digital level; adjust leveling feet if needed

7. 7

   Confirm customer is using dishwasher-specific detergent (not hand dishwashing liquid)

8. 8

   Confirm door was not opened during cycle

9. 9

   Check if there is too much water in tub (overfill); if yes, replace inlet valve or air guide

10. 10

    If float switch stuck in triggered position with no water in base, replace main PCB assembly

11. 11

    For AE report: document unit level, mounting bracket condition, detergent type, cycle history, water supply temperature, and whether door was opened

This Error Applies To

LG LDT7808ST Series Dishwashers (2017) (2017–present)