Error Code EE
EEPROM operation abnormal. Displayed in test mode only.
Moderate
Address soon - your appliance may not work properly
Also displayed as: EE
What This Means
Main PCB EEPROM failure
How to Fix
- 1
Enter diagnostic test mode to confirm EE code
- 2
Power cycle the dryer completely (unplug for 30 seconds, replug)
- 3
Re-enter diagnostic test mode; if EE persists, the main PCB has a faulty EEPROM
- 4
Replace main PCB assembly
- 5
Use anti-static precautions when handling the PCB (wrist strap or repeated ground touch)
This Error Applies To
LG DLEX5000V Series Dryers (2017) (2017–present)
Related Error Codes
Steam generator thermistor open or shorted. Displayed in test mode only.
Modem is abnormal. Displayed in test mode only.
Steam generator thermistor error — displayed in test mode only.
Humidity sensor failure.
FlowSense duct restriction at approximately 80% blockage — displayed after drying cycle.
Water supply pump AD value below 10 in test mode — pump failure or wiring fault.
FlowSense duct blockage at approximately 95% — critically restricted. Error displayed for 2 hours.
NFC module open or shorted. Displayed in test mode only.