Error Code E Id
Craft Ice Maker Sensor Error — Craft ice maker sensor short or open
Moderate
Address soon - your appliance may not work properly
Also displayed as: E Id
How to Fix
- 1
Check CON3 connector (pins 23~31) between Main PCB and craft ice maker sensor for loose or disconnected condition.
- 2
If connector is loose/disconnected, reconnect or repair the connector.
- 3
Measure craft ice maker sensor resistance at CON3 pins 23~31: 0 ohm = short (replace sensor), Open/infinity = open (replace sensor).
- 4
Compare measured resistance to temperature chart: -30°C=40k, -25°C=30k, -20°C=23k, -15°C=17k, -10°C=13k, -5°C=10k, 0°C=8k ohms.
- 5
If resistance is normal, explain to customer.
- 6
If sensor is verified good but error persists, replace the Main PCB.
This Error Applies To
LG LRSOC2306 Series Refrigerators
Related Error Codes
Freezer Sensor Abnormal — Freezer sensor short or open failure
UV/Nano LED Module Error — Bad UV LED module or poor connection of display and UV module; caused when feedback signals are abnormal (OPTIONAL feature)
Defrost Heater Abnormal — Defrost heater or thermal fuse short circuit or unplugged connector. Indicated 4 hours after trouble occurs.
Refrigerator Sensor Abnormal — Refrigerator sensor (upper part of refrigerator compartment) short or open failure
Defrost Sensor Abnormal — Defrost sensor short or open failure
Freezer Fan Motor Abnormal — Connection line of the fan motor is faulty, short or open. Display fault when operating fan motor for 65 seconds without feedback.
Ambient (Room) Temperature Sensor Abnormal — Room temperature sensor short or open
Ice Maker Unit (Motor) Abnormal — Ice maker step motor fault, Hall IC fault, or Li-wire short; faulty motor driving circuit. Display shows error if ice maker error occurs within 30 minutes after power on.