Error Code E IC
Defect of Mini Cubed ice maker kit — malfunction of Mini Cubed ice maker motor
Moderate
Address soon - your appliance may not work properly
Also displayed as: E IC
How to Fix
- 1
Step 1: Enter test mode by pressing test switch on Mini Cubed ice maker for more than 0.5 second.
- 2
Step 2: Observe if ice maker motor runs through test cycle: initial → ice ejection → water supply → water distribution.
- 3
Step 3: If motor does not move, check wiring harness from Main PCB to Mini Cubed ice maker.
- 4
Step 4: Measure motor winding resistance. Compare to specification.
- 5
Step 5: If motor resistance is abnormal, replace Mini Cubed ice maker motor assembly.
- 6
Step 6: If motor resistance is correct but motor does not respond, replace Main PCB.
This Error Applies To
LG LRYXC2606 Series Refrigerators
Related Error Codes
Defect of refrigerator sensor — short-circuit or disconnection of refrigerator sensor
Defect of freezer sensor — short-circuit or disconnection of freezer sensor
Defrosting failure — defrost sensor does not reach 40°F (5°C) within 80 minutes after defrost starts. Causes: disconnected thermal fuse, defective defrost heater, defective heater relay, drain tube blockage.
Defect of BLDC fan motor for freezer — no feedback signal from fan motor for more than 65 seconds
Defect of BLDC fan motor for ice compartment — no feedback signal from fan motor for more than 65 seconds. Causes: defect of BLDC motor connection, Drive IC, or TR.
Defect of BLDC fan motor for machine room — no feedback signal from condenser fan motor for more than 65 seconds
Defect of pantry sensor — short-circuit or disconnection of pantry sensor
Defect of ice-room sensor or ice maker sensor — short-circuit or disconnection