Error Code E UC
Defect of UVC LED — UVC LED disconnected or UVC LED failure. Check UVC LED connection.
Moderate
Address soon - your appliance may not work properly
Also displayed as: E UC
How to Fix
- 1
Step 1: Check connector between Sub PCB and UVC LED. If disconnected or loose, reconnect or repair connector.
- 2
Step 2: Enable 'Self Care' function. Measure voltage at CON2 14th Pin ~ 13th Pin. Expected: 11.4~12.6V (Self Care ON) or 0~1V (Self Care OFF). If not matching, replace Sub PCB assembly.
- 3
Step 3: Measure voltage at CON2 12th Pin ~ 13th Pin with Self Care ON. Expected: Not 0 or 5 (signal oscillating). If reads 0V or 5V (static), replace UVC LED.
- 4
Step 4: If connector is confirmed good and PCB voltage is correct but UVC LED still fails, replace UVC LED.
- 5
Step 5: If all checks pass, reconnect or repair connector.
This Error Applies To
LG LRYXC2606 Series Refrigerators
Related Error Codes
Defect of freezer craft ice maker sensor — short-circuit or disconnection of craft ice maker sensor
Defect of Mini Cubed ice maker kit — malfunction of Mini Cubed ice maker motor
Defect of refrigerator sensor — short-circuit or disconnection of refrigerator sensor
Defect of freezer sensor — short-circuit or disconnection of freezer sensor
Defrosting failure — defrost sensor does not reach 40°F (5°C) within 80 minutes after defrost starts. Causes: disconnected thermal fuse, defective defrost heater, defective heater relay, drain tube blockage.
Defect of BLDC fan motor for freezer — no feedback signal from fan motor for more than 65 seconds
Defect of BLDC fan motor for ice compartment — no feedback signal from fan motor for more than 65 seconds. Causes: defect of BLDC motor connection, Drive IC, or TR.
Defect of BLDC fan motor for machine room — no feedback signal from condenser fan motor for more than 65 seconds