Error Code LC

Water is leaking inside the base of the dishwasher

Also displayed as: LC

What This Means

Overfill occurred in the tub; Water from a leak flowed to the bottom tray; Water inlet valve leaking — foreign substance preventing valve from closing; Drain pump not operating normally; Leakage switch is dirty or damaged; Float is too high or something is holding the micro switch on; Drain hose is obstructed or kinked; Base float is damaged or too dirty; Incorrect wiring to micro switch after previous repair

First Thing to Check

Parts Involved

How to Fix

1. 1

   1. Check the connections for the leakage switch connector and reconnect

2. 2

   2. Check whether the water valve operates normally — see 4C error diagnostics

3. 3

   3. Check whether the drain pump operates normally — replace if faulty

4. 4

   4. Check whether water is supplied even in small amounts when the valve should be off — remove foreign material from the water valve or replace it

5. 5

   5. Check whether there is any trace of water leakage on the top of the case leakage switch — clean the leakage switch

6. 6

   6. Check if the float is too high or something is holding the micro switch on — repair the float and leakage switch

7. 7

   7. Check if drain hose is obstructed or kinked — clean or adjust hose

8. 8

   8. Check base float for damage or dirt — replace or clean

9. 9

   9. Check for incorrect wiring to the micro switch after previous repair — correct the connections

10. 10

    10. Check the DC voltage of the Main PBA — measure voltage between pin 1 (Pink) and pin 3 (Blue) of the main PBA CN6 connector. Normal (Door Close): 0V, Normal (Door Open): 11.4V to 12.6V

This Error Applies To

Samsung DW50T6060U Series Dishwashers (2020) (2020–present)