Error Code 9C2
The washer is getting too much electrical power
Moderate
Address soon - your appliance may not work properly
Also displayed as: 9C2
What This Means
Consumer's power conditions are unstable; Over voltage being supplied; Voltage spikes or surges on the circuit; Main PBA fault (sometimes)
What actually causes this:
There's an electrical surge or overvoltage condition on the circuit the washer is plugged into
First Thing to Check
Unplug the washer for a minute, then try again — if it keeps happening, check other appliances on the same circuit
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions — make sure to check the operating voltage
- 2
2. Connect a tester to the internal power terminals during operation
- 3
3. Check the voltages for over voltage conditions
- 4
4. Check whether a plug receptacle is used
- 5
5. If power is stable, check Main PBA
This Error Applies To
Samsung WA50M7450A Series Washers (2018) (2018–present)
Related Error Codes
The washer's door release module isn't communicating properly
The washer's WiFi module isn't communicating properly
The washer can't tell how much water is inside
The washer's motor can't spin properly
The washer isn't getting water when it needs it
The incoming water is too hot for the selected cycle
The washer can't pump the water out
The washer isn't getting enough electrical power