Error Code 4E2
The incoming water is too hot for the selected cycle
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4E2
What This Means
Temperature of water supplied through the dry valve during a dry cycle sensed higher than 70°C; Water temperature sensed higher than 50°C in Wool or Lingerie courses; Hot water supply line connected where cold water should be
What actually causes this:
The hot and cold water hoses are probably swapped at the back of the washer, sending hot water when cold is expected
First Thing to Check
Check if your hot and cold water hoses are connected to the correct inlets on the back of the washer
Parts Involved
How to Fix
- 1
1. Check that hot and cold water supply hoses are connected to the correct inlets
- 2
2. Verify hot water heater temperature setting is not excessive
- 3
3. Check temperature sensor operation
- 4
4. If hoses are correct, check the water supply valve and temperature sensor
This Error Applies To
Samsung WF42H5200A Series Washers (2014) (2014–present)
Related Error Codes
The washer motor is struggling to spin the drum
Your washer can't tell how much water is inside
Your washer isn't getting water
Your washer can't pump the water out
Your washer is getting unreliable power from the outlet
A control module inside your washer has lost its connection
The motor speed controller lost its connection to the main control board
Your washer is getting too much power from the outlet