Error Code DC
The washer door isn't closing or locking properly
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC
What This Means
Switch contact error because of deformation of the door hook; Door is pulled by force; Door pushed due to pressure difference from internal temperature changes during Boil wash; Door is not opened after the door open operation; Door is not locked after the door close operation
What actually causes this:
The door wasn't pushed firmly shut, or something is caught in the door seal preventing it from closing
First Thing to Check
Open the door, make sure nothing is caught in the rubber seal, and close it firmly until you hear it click
Parts Involved
How to Fix
- 1
1. If a DC error occurs, check whether it occurs during the Boil cycle
- 2
2. Check the door — if detected that door is open/close during Boil cycle
- 3
3. Check the door switch resistance — resistance of Pin 1 and Pin 3 must be approximately 175 Ohm
- 4
4. Check and repair the power wire connections and insulation state
- 5
5. Replace if faulty
This Error Applies To
Samsung WF45K6 Series Washers (2018) (2018–present)
Related Error Codes
The washer's motor controller lost communication with the main board
The washer's door lock mechanism isn't engaging properly
The washer's vibration sensor board has a problem
The washer's WiFi module lost communication with the main board
The washer's display screen lost communication with the main board
The incoming water is too hot for the delicate cycle you selected
Your washer is getting too much electrical power
The washer's door relay module lost communication with the main board