Error Code E Id
Defect of freezer craft ice maker sensor — short-circuit or disconnection of craft ice maker sensor
Moderate
Address soon - your appliance may not work properly
Also displayed as: E Id
How to Fix
- 1
Step 1: Check connector between Main PCB and craft ice maker sensor.
- 2
Step 2: Measure sensor resistance. Compare to reference table for current ambient temperature.
- 3
Step 3: If 0 ohm (short), replace sensor.
- 4
Step 4: If OL/infinite (open), replace sensor.
- 5
Step 5: If resistance is correct, replace Main PCB.
Other Error Codes for LRYXC2606S
Defect of Mini Cubed ice maker kit — malfunction of Mini Cubed ice maker motor
Defect of refrigerator sensor — short-circuit or disconnection of refrigerator sensor
Defect of freezer sensor — short-circuit or disconnection of freezer sensor
Defrosting failure — defrost sensor does not reach 40°F (5°C) within 80 minutes after defrost starts. Causes: disconnected thermal fuse, defective defrost heater, defective heater relay, drain tube blockage.
Defect of BLDC fan motor for freezer — no feedback signal from fan motor for more than 65 seconds
Defect of BLDC fan motor for ice compartment — no feedback signal from fan motor for more than 65 seconds. Causes: defect of BLDC motor connection, Drive IC, or TR.
Defect of BLDC fan motor for machine room — no feedback signal from condenser fan motor for more than 65 seconds
Defect of pantry sensor — short-circuit or disconnection of pantry sensor