Error Code AE3
A control module inside your washer has lost its connection
Moderate
Address soon - your appliance may not work properly
Also displayed as: AE3
What This Means
Signals between DR Module and main PBA not sensed due to communication error; Incorrect or loose connector connections between DR Module and main PBA; Faulty soldering on DR Module
What actually causes this:
A plug inside the washer came loose or has a bad solder joint on the circuit board
First Thing to Check
Turn off the washer, unplug it for 5 minutes, then plug it back in and try again
Parts Involved
How to Fix
- 1
1. Check connector connections between DR Module and main PBA carefully — look for incorrect or loose connections
- 2
2. Remove the DR Module and check for any faulty soldering
- 3
3. If connections are secure and soldering is intact, replace the DR Module or Main PBA
Other Error Codes for WF42H5200AF
The WiFi module in your washer lost its connection to the main board
The control panels inside your washer aren't communicating with each other
The display panel lost its connection to the main control board
One of the buttons on your washer is stuck
The water heater in your washer isn't working properly
Your washer door isn't closing or locking properly
The washer motor is struggling to spin the drum
The incoming water is too hot for the selected cycle