Error Code 9E2
Your washer is getting too much power from the outlet
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9E2
What This Means
Consumer power conditions are abnormal; Operating voltage is out of range (over voltage); Plug receptacle is used (extension cord); Main PBA fault (sometimes)
What actually causes this:
The power coming from your outlet is fluctuating or too high — could be a household electrical issue
First Thing to Check
Unplug the washer, wait a minute, and plug it directly into a wall outlet (not an extension cord)
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions — verify operating voltage
- 2
2. Connect a tester to internal power terminals during operation and observe
- 3
3. Check whether an extension cord or plug receptacle is used
- 4
4. If voltage is correct, check Main PBA
Other Error Codes for WF42H5200AW
The WiFi module in your washer lost its connection to the main board
The control panels inside your washer aren't communicating with each other
The display panel lost its connection to the main control board
One of the buttons on your washer is stuck
The water heater in your washer isn't working properly
Your washer door isn't closing or locking properly
The washer motor is struggling to spin the drum
The incoming water is too hot for the selected cycle