Error Code 9C2
Your washer is getting too much electrical power
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9C2
What This Means
Consumer power conditions are abnormal; Over voltage supplied; Main PBA fault (sometimes)
What actually causes this:
The electrical supply voltage to your home or that circuit is higher than normal
First Thing to Check
Unplug the washer and wait a few minutes, then plug it back in — if it persists, you may have a wiring issue
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions
- 2
2. Check the operating voltage with a tester connected to internal power terminals
- 3
3. Check the voltages for over-voltage condition
- 4
4. If power supply is confirmed normal, replace Main PBA
Other Error Codes for WF45K6500AW
The washer's motor controller lost communication with the main board
The washer's door lock mechanism isn't engaging properly
The washer's vibration sensor board has a problem
The washer's display screen lost communication with the main board
The washer's door relay module lost communication with the main board
Your washer can't tell how much water is inside the tub
Your washer isn't getting enough water to run the cycle
Your washer isn't getting enough electrical power