Error Code 9C1
The washer is not getting enough electrical power to run properly.
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9C1
What This Means
Under voltage supplied to the washer; Use of a plug receptacle or extension cord causing voltage drop; Home electrical system power issues; Main PBA fault
What actually causes this:
Usually caused by using an extension cord or sharing an outlet with other high-draw appliances.
First Thing to Check
Make sure the washer is plugged directly into a wall outlet and not through an extension cord or power strip.
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions and verify the operating voltage
- 2
2. Connect a tester to the internal power terminals during the Boil operations and observe the washing machine's operation
- 3
3. Check the voltages for under or over voltage condition
- 4
4. Check whether a plug receptacle or extension cord is used - when the connecting wire is 1m, a momentary low voltage may drop up to 10V
- 5
5. If power supply is confirmed stable, check the main PBA
Other Error Codes for WV60A9900AV
The washer's heater got dangerously hot and the machine shut itself off for safety.
The laundry load is not evenly distributed, causing the washer to vibrate too much during spin.
The incoming water is too hot for the selected gentle cycle.
The washer cannot pump out the water after a wash or rinse cycle.
The washer is not getting enough water or no water at all.
The washer's WiFi module has lost its connection to the main board.
The washer cannot detect the water level inside the tub.
The washer is getting too much electrical power, which can damage it.