Error Code PF
Power failure – house fuse blown, circuit breaker tripped, or power outage occurred
Moderate
Address soon - your appliance may not work properly
Also displayed as: PF
How to Fix
- 1
Check home circuit breaker panel and reset any tripped breaker.
- 2
Replace blown house fuse (do not increase fuse capacity).
- 3
If circuit overload is causing breaker trips, have a qualified electrician correct the overload.
- 4
If breaker/fuse are good and error persists, verify outlet voltage is 208–240Vac.
Other Error Codes for DLG8401VE
Temperature sensor (thermistor) failure – thermistor shorted
FlowSense duct blockage indicator – four bars shown during drying cycle or 'dso' shown after drying; significant ductwork restriction detected
FlowSense duct blockage – ductwork is approximately 95% blocked (displayed for 2 hours after cycle ends)
Temperature sensor (thermistor) failure – thermistor open circuit
Humidity sensor (electrode/moisture sensor) failure
Power supply error – electric dryer power cord not connected correctly or house power supply is incorrect / insufficient voltage (below 240V on L1-L2 leg reaching PCB)
FlowSense duct blockage – ductwork is approximately 90% blocked
No power / power cord not connected correctly (electric dryer only)