Error Code tE2
Temperature sensor (thermistor) failure – thermistor shorted
Moderate
Address soon - your appliance may not work properly
Also displayed as: tE2
How to Fix
- 1
Power off the dryer.
- 2
Disconnect NA6 connector from main PCB.
- 3
Measure resistance between thermistor terminals. Compare to Table 1 (see tE1 steps).
- 4
If resistance reads near zero or far below Table 1 values → thermistor is shorted. Replace thermistor.
- 5
If thermistor resistance is within range → Check for short in harness between thermistor and NA6 connector.
- 6
If harness is good → Replace main PCB.
This Error Applies To
LG DLE8400VE Series Dryers
Related Error Codes
No power / power cord not connected correctly (electric dryer only)
FlowSense duct blockage indicator – four bars shown during drying cycle or 'dso' shown after drying; significant ductwork restriction detected
FlowSense duct blockage – ductwork is approximately 95% blocked (displayed for 2 hours after cycle ends)
Temperature sensor (thermistor) failure – thermistor open circuit
Humidity sensor (electrode/moisture sensor) failure
Power supply error – electric dryer power cord not connected correctly or house power supply is incorrect / insufficient voltage (below 240V on L1-L2 leg reaching PCB)
Gas supply failure – gas not being supplied to the dryer (gas model only)
Steam pump failure – pump AD (analog-to-digital) value below 10 during diagnostic test (steam models)