Error Code d80

Flow Sense shows 80% duct restriction after a drying cycle — ductwork needs attention

Also displayed as: d80

How to Fix

1. 1

   Do not use dryer until exhaust system has been inspected.

2. 2

   Check the outside dryer vent while dryer is operating to confirm airflow.

3. 3

   Inspect the full duct run for lint buildup, crushed duct, or physical blockage.

4. 4

   Check vent hood for damage or lint clogging; ensure area around vent hood is clear.

5. 5

   Reduce duct run length or number of elbows if the run is excessively long or complex.

6. 6

   Clean ductwork thoroughly.

7. 7

   After cleaning, run the FlowSense installation test: press and hold Temp Control + Signal buttons, then press POWER; press START/PAUSE to begin test.

8. 8

   If FLOW SENSE indicator shows four bars or d80 persists after cleaning, install a shorter or straighter duct run.

9. 9

   Opening door or pressing POWER will clear the display indicator after two hours.

This Error Applies To

LG DLEY1701VE Series Dryers