Error Code d95
Ductwork approximately 95% blocked — Flow Sense detection — severe restriction
Moderate
Address soon - your appliance may not work properly
Also displayed as: d95
How to Fix
- 1
Stop using dryer immediately — operating with this restriction is dangerous and could result in fire or property damage.
- 2
Clean or replace the entire exhaust duct system before operating.
- 3
Inspect for crushed duct, damaged duct, or complete blockage at vent hood or transitions.
- 4
After repair, run FlowSense installation test: hold Temp Control + Signal, press POWER, press START/PAUSE; confirm no bars display at end of test.
- 5
If problem persists after duct replacement, check the FlowSense sensor on the blower.
This Error Applies To
LG DLEY1701VE Series Dryers
Related Error Codes
Humidity/moisture sensor failure
Power failure — same causes as PS code
Flow Sense shows 80% duct restriction after a drying cycle — ductwork needs attention
No power detected — power supply issue
Steam pump error — pump AD value below threshold during diagnostic test mode
Installation test mode successfully activated — Flow Sense installation test
Temperature sensor (thermistor) failure — short circuit or secondary thermistor fault
Power supply error — electric dryer power cord not connected correctly, or house power supply is incorrect