Error Code BC2
A button on the control panel is stuck or being held down.
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Power button continuously pressed or stuck; Another button continuously pressed or stuck; Service PBA holding screws fastened too tight causing button contact; Main PBA switching IC failure; Main relay connections incorrect
What actually causes this:
A button on the washer's control panel is physically stuck, often from spilled detergent or grime building up around the buttons.
First Thing to Check
Press each button on the control panel to make sure none are stuck. Wipe around the buttons with a damp cloth.
Parts Involved
How to Fix
- 1
1. Check the contact between control panel buttons and their corresponding tact switch -- there must be a gap.
- 2
2. Check whether the service PBA holding screws are fastened too tight. If so, loosen them slightly.
- 3
3. The error occurs after approx. 30 seconds of continuous button press.
- 4
4. If the main PBA switching IC on/off has occurred, replace the main PBA.
- 5
5. Check that main relay connections are correct. If no issue found, replace the main PBA.
This Error Applies To
Samsung WA51DG5505 Series Washers (2024) (2024–present)
Related Error Codes
The water level sensor is not reading correctly.
The washer motor is not running properly.
The washer is not getting water.
The water hoses are connected to the wrong faucets.
The washer cannot pump the water out.
The washer's vibration sensor is not working.
The washer is getting too much voltage from the outlet.
The washer is not getting enough voltage from the outlet.