Error Code 8E
The washer's vibration sensor has stopped working
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8E
What This Means
MEMS sensor defective; MEMS sensor PBA fault; Wire connector terminals disconnected
What actually causes this:
The vibration sensor that helps the washer balance during spin has failed
First Thing to Check
Unplug the washer for a minute, then plug it back in and restart the cycle
Parts Involved
How to Fix
- 1
1. Check the MEMS sensor and PBA
- 2
2. Check the wire connector terminals
- 3
3. Verify MEMS sensor output is within 0.5V to 4.5V range
This Error Applies To
Samsung WA5471ABP Series Washers (2024) (2024–present)
Related Error Codes
The washer's motor can't spin properly
The washer can't detect the water level inside the tub
The washer can't drain the water out
The washer door isn't closing or latching properly
The washer isn't filling with water properly
A button on the control panel appears stuck or is being held down
The washer's control boards can't communicate with each other
The washer's lid won't unlock after the cycle