Error Code 8C2
The washer's vibration sensor is not working
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C2
What This Means
MEMS PBA is defective; MEMS PBA wire disconnection
What actually causes this:
The vibration sensor board has failed
First Thing to Check
Turn off the washer, wait 2-3 minutes, and turn it back on — if the error persists, it needs service
Parts Involved
How to Fix
- 1
1. Check wire connections to the MEMS PBA
- 2
2. Replace the MEMS PBA
This Error Applies To
Samsung WA54CG7550 Series Washers (2024) (2024–present)
Related Error Codes
The dryer temperature sensor is not reading correctly
The cold water hose is hooked up wrong
The water level sensor cannot detect the water level correctly
The washer's motor has stopped working
The washer is not getting any water
The washer cannot drain the water out
The washer is getting too much voltage from the outlet
The washer is not getting enough voltage from the outlet