Error Code BC2
A button on the control panel appears to be stuck
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Power button is continually pressed (stuck); A button other than the Power button is continually pressed; Control panel button is making contact with its corresponding tact switch without being pressed; Service PBA holding screws are fastened too tight; Main PBA switching IC is defective; Main relay connections are incorrect
What actually causes this:
A button on the control panel got stuck down, or the circuit board screws are too tight and pushing a switch
First Thing to Check
Press each button on the control panel to see if any feel stuck — gently press and release them all
Parts Involved
How to Fix
- 1
1. Check the contact between control panel buttons and their corresponding tact switches — there must be a gap
- 2
2. Check whether the service PBA holding screws are fastened too tight; loosen them a little if needed
- 3
3. If the main PBA switching IC on/off check has occurred, replace the main PBA
- 4
4. Check main relay connections — 'E2' check occurs if main relay connections are incorrect
- 5
5. If there is no problem with the connections, replace the main PBA
This Error Applies To
Samsung WA54CG7550 Series Washers (2024) (2024–present)
Related Error Codes
The dryer temperature sensor is not reading correctly
The cold water hose is hooked up wrong
The water level sensor cannot detect the water level correctly
The washer's motor has stopped working
The washer is not getting any water
The washer cannot drain the water out
The washer is getting too much voltage from the outlet
The washer is not getting enough voltage from the outlet