Error Code PC1
The clutch sensor is giving a wrong signal
Moderate
Address soon - your appliance may not work properly
Also displayed as: PC1
What This Means
Clutch hall sensor is sending incorrect signal after position detection; Clutch assembly wiring issue; Main PCB is defective
What actually causes this:
The sensor inside the clutch mechanism is sending bad data after initially connecting
First Thing to Check
Unplug the washer for one minute, plug it back in, and try again
Parts Involved
How to Fix
- 1
1. Turn off the washer, unplug it, wait one minute, and plug it back in
- 2
2. Check the clutch hall sensor wiring connections
- 3
3. If the information code remains, contact service
This Error Applies To
Samsung WA54CG7550 Series Washers (2024) (2024–present)
Related Error Codes
The dryer temperature sensor is not reading correctly
The cold water hose is hooked up wrong
The water level sensor cannot detect the water level correctly
The washer's motor has stopped working
The washer is not getting any water
The washer cannot drain the water out
The washer is getting too much voltage from the outlet
The washer is not getting enough voltage from the outlet